30D12150P Desktop Power Supply

The 30D12150P Wall mount power supply can be used to power any of the Ethernet Direct Industrial products.

Click to Enlarge Image

Product Specification

INPUT ~ AC Input Voltage: 100 - 240V AC ~ AC Input Frequency: 50 / 60 Hz ~ AC Input Current - 230V AC (max): 0.2A ~ AC Inrush Current* - 230V AC, 50Hz: 50A ~ Primary current protection: An internal fuse on the AC input line is provided. ~ Configuration: 3-conductors, OUTPUT ~ Normal DC Output Voltage: +12.0V ~ Minimum Load Current: 0.0A ~ Maximum Load Current: 1.5A ~ Maximum Output Power: 18W ~ Ripple and Noise: 120mV ~ Over-voltage protection (max): 15.75V DC. ~ Total Output Regulation: +/- 5% ~ Dynamic Load Regulation: +/- 5% ~ Short-circuit protection (max): 5W ~ Efficiency: 65% minimum at normal input voltage and full load. ~ Drop-out: With half cycle input voltage drop-out, the unit shall meet theregulation requirement and operate within the prescribed voltages with a drop-out pulse repetition rate of 500mS under fullload and with normal AC input voltage. ~ Open-circuit protection: When primary power is applied with no load on any output level, nodamage or hazardous conditions should occur. MECHANICAL ~ Dimensions: 100(L) x 50(W) x 35(H)mm. ~ Weight: 200g ~ Input Plug Type: Desk type, 3-conductors, ~ Output Cord: Wire: SPT-1, VW-1, 18AWG, 1828mm. ~ Output Plug: 10(L) x 5.5(D) x 2.1(ID)mm ENVIRONMENTAL ~ Operating Temperature: 0ºC to +40ºC ~ Storage Temperature: -20ºC to +60ºC ~ Operating Humidity: 20 ~ 85 % RH. Non-condensing ~ Storage Humidity: 5 ~ 95 % RH. Non-condensing SAFETY ~ Dielectric withstanding voltage test (Hi-pot test) input to output: 1,800V AC, 10mA, 1 second OR 2,545V DC, 10mA, 1 second. ~ Dielectric withstanding voltage test (Hi-pot test) input to ground: 1,800V AC, 10mA, 1 second OR 2,545V DC, 10mA, 1 second. ~ Insulation Resistance: > 100MΩ at 500V DC between Primary Active, Neutral line andsecondary. ~ Leakage Current: 0.75mA maximum at normal AC input voltage and frequency RELIABILITY ~ MTBF: 50,000 hours ~ Burn-in Test: 4 hours at 40ºC +/- 5ºC, normal input voltage, 80% of maximum load.

Ordering Information